5_25_floppy_drives:alps_dfc642b
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
5_25_floppy_drives:alps_dfc642b [2021/06/11 09:11] – js | 5_25_floppy_drives:alps_dfc642b [2021/06/11 11:17] (current) – [84 track seeking] js | ||
---|---|---|---|
Line 15: | Line 15: | ||
^ Disk locking | Lever | | ^ Disk locking | Lever | | ||
^ Known colors |< | ^ Known colors |< | ||
- | | < | + | | < |
</ | </ | ||
</ | </ | ||
Line 34: | Line 34: | ||
{{pdfjs 100%, | {{pdfjs 100%, | ||
++++ | ++++ | ||
+ | |||
+ | ===== Modifications ===== | ||
+ | ==== 84 track seeking ==== | ||
+ | Unmodified drives will not be able to seek 84 tracks. A small modification is required to enable this. | ||
+ | |||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | The modification can be performed by following these steps: | ||
+ | - Loosen the two screws holding the end stop of the stepper motor as pictured. | ||
+ | - Move the end stop all the the way up, away from the axle. | ||
+ | - Tighten the screws while retaining the end stop in the upper position. |
5_25_floppy_drives/alps_dfc642b.1623395479.txt.gz · Last modified: 2021/06/11 09:11 by js