5_25_floppy_drives:ye_data_yd-380
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 5_25_floppy_drives:ye_data_yd-380 [2021/06/11 11:53] – js | 5_25_floppy_drives:ye_data_yd-380 [2021/06/13 19:20] (current) – [Type 1711] js | ||
|---|---|---|---|
| Line 31: | Line 31: | ||
| The 1711 type uses the Yaskawa GCMK-77X or Sankyo E2SLR3 motor board. | The 1711 type uses the Yaskawa GCMK-77X or Sankyo E2SLR3 motor board. | ||
| === Pictures === | === Pictures === | ||
| - | | {{: | + | | {{: |
| | {{: | | {{: | ||
| - | | {{: | + | | {{: |
| ==== Type 1718 ==== | ==== Type 1718 ==== | ||
| Line 58: | Line 58: | ||
| The modification can be performed by following these steps: | The modification can be performed by following these steps: | ||
| - | - Place a flat-head screwdriver | + | - Unscrew the springs that hold the head assembly guild rod on the stepper motor side. |
| - | - Tap the back of the screwdriver lightly but firmly to move the spring towards the spindle motor. | + | - Pull out the guide rod about half way. |
| - | - Do this for both sides of the spring. | + | - Use a rotary tool to grind down the head assembly |
| + | - Clean the drive of any metal dust. | ||
| + | - Push the guide rod back into its resting position. | ||
| + | - Screw down the springs that hold the guild rod in place. | ||
5_25_floppy_drives/ye_data_yd-380.1623405237.txt.gz · Last modified: 2021/06/11 11:53 by js