5_25_floppy_drives:ye_data_yd-380
Table of Contents
| Manufacturer | YE Data | ||||
|---|---|---|---|---|---|
| Model | YD-380 | ||||
| Density | HD, DD/2D | ||||
| Sides | DS/2S, SS/1S | ||||
| Rotation speed | 300, 360 | ||||
| Maximum seekable tracks | 841) / 83 | ||||
| Interface | Shugart (PC-AT compatible) |
||||
| Data Connnector | 34 position card edge | ||||
| Power Connnector | 4 pin Molex | ||||
| Head movement | Metal belt | ||||
| Head loading | Solenoid | ||||
| Disk loading | Lever | ||||
| Known colors |
|
YE Data YD-380
The YD-380 is a 5.25“ double sided high density floppy drive made by YE Data. It uses a metal belt to facilitate head movement and locks the disk with a lever. Head loading is done with a solenoid.
It uses the PN128XXX-31 control board.
Types
The YD-380 model has a number of types. They can be identified via the label that is located on the back of the drive (connector side).
Type 1711
Description
The 1711 type uses the Yaskawa GCMK-77X or Sankyo E2SLR3 motor board.
Pictures
 |    |   |
  |
||
   |
Type 1718
Description
The 1718 type uses the Yaskawa GCMK-77X motor board.
Pictures
 |  |  |
 |
||
 |
Jumper settings
PN128XXX-31
Modifications
84 track seeking
Unmodified drives will not be able to seek 84 tracks. A major modification is required to enable this.
The modification can be performed by following these steps:
- Unscrew the springs that hold the head assembly guild rod on the stepper motor side.
- Pull out the guide rod about half way.
- Use a rotary tool to grind down the head assembly end stop as pictured.
- Clean the drive of any metal dust.
- Push the guide rod back into its resting position.
- Screw down the springs that hold the guild rod in place.
1)
Modification is required
5_25_floppy_drives/ye_data_yd-380.txt · Last modified: 2021/06/13 19:20 by js